I just finished Installing my 3 Ton Carrier TN6 with the Infinity T stat. Went through all the setup, Ran new ducting. Passed the air flow test with where It should be. House Is run with 8s to all rooms.
My problem Is that the Stat constantly over shoots the set point by 2*. Set point Is 72* and I will always see It go to 74* before shutting down.
Quick Google search shows their used to be a Anticipator setting In the older Infinity T stats but not this one? Its the newest model ( Black ) with the rounded bottom right edge.
I cant for the life of me figure out how to get It to stop this.
Air flow test passed at 1250 CFM .6 static.
Gas pressure 3.2 HF - 1.8 LF.
Dip switch 1-5 On for better air flow.
Anyone have this problem and found a solution to It?
Thanks
My problem Is that the Stat constantly over shoots the set point by 2*. Set point Is 72* and I will always see It go to 74* before shutting down.
Quick Google search shows their used to be a Anticipator setting In the older Infinity T stats but not this one? Its the newest model ( Black ) with the rounded bottom right edge.
I cant for the life of me figure out how to get It to stop this.
Air flow test passed at 1250 CFM .6 static.
Gas pressure 3.2 HF - 1.8 LF.
Dip switch 1-5 On for better air flow.
Anyone have this problem and found a solution to It?
Thanks
source https://hvac-talk.com/vbb/showthread.php?2222915-Carrier-Infinity-T-stat-No-Heat-Anticipator-setting&goto=newpost
No comments:
Post a Comment